Welcome to ranzlakaz.mu

Logo-Ranzlakaz

Grease Trap Duraco

5,000.0056,000.00 incl. VAT

Share to :

Description

Free Delivery Around the Island
This Product is not Delivered to Rodrigues

Grease Trap Capacity: 140L | 200L | 350L | 1800L | 3000L | 4700L |

Common wastewater from the kitchen sink contains small
 amounts of Fats, Oil, Grease and Solids (FOGS) which
 enter grease trap.  
The solid food particles sink to the bottom while the
 lighter grease and oil floats to the top and form a
 floating scum layer. 
The latter is very slowly digested and broken down by
 the microorganisms during the aerobic digestion process.

The relatively grease-free water is then fed into an
 absorption pit. 
The food solids at the bottom and floating oil and grease
 must be periodically removed. 
A traditional grease trap is not a food disposal unit. 
Unfinished food, gravy and sauces must be scraped into
 the garbage or food recycling bin.

INSTALLATION PROCESS
Respect the following steps when installing a Duraco grease trap:
Step 1: Location: –
Determine a suitable area to install the grease trap. 
The unit must be place in an outside area near the
 kitchen sink and accessible enough for regular maintenance.
Step 2: Connection: –
The Grease trap has only two connectors. 
The inlet should be connected to the sink pipe and the
 outlet to the absorption pit.
Step 3Excavation: –
Dig to a depth that will allow the grease trap cover
 to come flush with the ground.
For domestic models (140, 200 and 350 L) allow 160mm
 around the tank. For industrial models (1,800, 3,000
 and 4,700 L) allow 230 mm on both sides and both ends
 of the tank.
Step 4Bedding: –
Allow for a minimum of 150 mm of compacted bedding
 material rock sand. Bed the grease trap and make
 sure it is placed levelled.
The grease trap is supplied with PVC sleeves at the
 inlet and outlet. 
The inlet and outlet pipes should be glued to the
 sleeves using standard PVC glue.
Step 5Backfilling: –
Ensure the tank lid is properly screwed on the grease
 trap. 
Fill the tank with water through the inlet as you
 backfill, keeping the water level even with the
 backfill level. 
This will prevent possible distortion of the tank and
 its manhole. Do not remove the lid until the end of
 the backfill process.
Backfill in layers of 200 mm at a time and properly
 compact each layer. 
Ensure to compact each end first. 
Compact the backfill under the inlet and outlet before
 fixing the pipes.
For the industrial models, the maximum backfill over 
the top is 300 mm.
NOTE: In case the grease trap needs to be installed with
 more than 300mm of soil above its top, it must be
 protected by a heavy-duty concrete slab. 
THE SLAB MUST REST ON FIRM SOIL AROUND THE TANK
Step 6Polyethylene (P.E) Extension: – 
(for industrial models ONLY)
In case the manhole screwed lid does not reach the 
ground level, a polyethylene extension will be required. 
Install the extension to the manhole outlet before starting
 the backfill process. Make use of Duraco 
extension EXCLUSIVELY. 
The screwed lid supplied with grease trap will fit
 the P.E extension.
Step 7Drain Field Material: –
The home sewer drain needs to slope at least ¼ inch per foot
 downhill to the inlet of the grease trap and the outlet pipe
 must cater for a downhill slope of 1/8 inch per foot to the
 absorption pit. 
The absorption pit should be at a distance of not more than 3m
 from the grease trap and its volume must be at least similar
 to that of the grease trap.

CAUTION
Failure to comply with the points below voids the warranty.
Do not install any tank in water saturated clay or in high
 water table. 
The tank may collapse and its content will escape.
Tanks are not fire-resistant. 
Do not store them near an open flame or heat in
 excess of 180°F,
Do not install any tank under the path of vehicles
 or heavy equipment unless protected by a heavy-duty
 concrete slab, without resting on the grease trap.
When the grease trap is pumped for normal maintenance;
 it should be refilled immediately.
Duraco grease trap is designed for underground use only.
Protect the tank from sharp objects which could cause leakage.
Avoid abusive use of detergent.

Additional information

Capacity

140L, 200L, 350L, 1800L, 3000L, 4700L

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.

< Back
There are no products in your cart.
Product total: ₨0.00
Pay now
0
0 items in your cart - ₨0.00
Pay now